55
Appendix
System does
not record
message
• Make sure answering system is on (page 38).
System does
not answer
after correct
number of
rings
• Make sure that the answering system is on (page 38).
• If toll saver is activated, the number of rings changes to two
when there are new messages waiting (page 41).
• In some cases, the system may be affected by the ringing
system used by the local telephone company.
• If the memory is full or the system is off, the system will
answer after 10 rings.
Common cure
for electronic
equipment
If the telephone does not seem to be responding normally,
try putting the cordless handset in its charger. If it does not
seem to respond, do the following (in the order listed):
• Disconnect the power to the telephone base.
• Disconnect the cordless handset battery, and spare battery,
if applicable.
• Wait a few minutes.
• Connect power to the telephone base and charger.
• Re-install the telephone base and charger and place the
cordless handset into the charger.
• Wait for the cordless handset to re-establish its connection
with the base. Allow up to one minute for this to take place.
System does
not respond
to remote
commands
• Make sure to enter your remote access code correctly
(pages 45).
• Make sure you are calling from a touch-tone telephone.
When dialing a number, you should hear tones. If you hear
clicks, it is not a touch-tone telephone and cannot activate
the answering system.
• The answering system may not detect the remote access
code while your announcement is playing. Try waiting until
the announcement is over before entering the code.
• There may be noise or interference on the telephone line
you are using. Press dial pad buttons firmly.
Announcement
message is not
clear
• When you record your announcement, make sure you speak
in a normal tone of voice, about nine inches from the tel-
ephone base.
• Make sure there is no background noise (TV, music, etc.)
while recording.
Troubleshooting