AT&T E5937 user manual Remote access

1. Dial your telephone number from any touch-tone phone.

2. When system answers, enter a two-digit remote access code (19 unless you have changed it).

3. Enter remote commands (see list at right).

4. Hang up to end call and save all undeleted messages.

NOTE: If you pause for more than 10 seconds during remote access, you will hear a help menu listing all features & commands. If you issue no command for another 20 seconds, the call will end automatically.

Answering system operation

Remote access

A two-digit security code is required to access your answering system from any touch-tone phone. This code is 19 by default; see page 34 to change it.

Play all messages	Press to hear all messages.
1
Play new messages	Press to hear new messages.
2
Delete the message	Press during playback to delete current
	message. Press 3 twice to delete all old
3
	messages while in remote access idle
33
	mode (message not being played).
Repeat or go back	Press during the caller’s message to
4	repeat the message. Press during the
	beginning of the day and time announce-
	ment to go back to the previous caller’s
	message.
Stop	Press to stop any operation (stop play-
5	back, stop recording).
Skip to next message	Press to skip current message and
6	advance to next message.
Review announcement	Press to review current outgoing
#7	announcement.
Record announcement	Press * 7, wait for beep, then begin
*7to begin recording	speaking. Press 5 to stop recording and
5to stop recording	hear playback of the new announcement.
Record memo	Press 8, wait for beep, then begin speak-
8to begin recording	ing. Press 5 to stop recording.
5to stop recording
Review remote access code	Press # 9 to review remote access code.
#9
Change remote access code	Press * 9 to change remote access code,
*9	then enter desired remote access code
	from 10-99.

38