10
Appendix
• Make sure the handset is placed in the charger correctly.
The CHARGE light on the charger should be on.
• Remove the battery from the handset and install it in the
spare battery compartment on the side of the telephone
base and let it charge for 16 hours. Then re-install the
charged battery pack into the handset.
• If the cordless handset is in the charger or in the telephone
base but the CHARGE light is not on, refer to The charge
light is off in the section below.
• It may be necessary to purchase a new battery. Please
refer to the battery section of this user’s manual.
• The telephone might be malfunctioning. Please refer to
the warranty section of this user’s manual for further
instruction.
The battery
does not
charge in
the handset
-OR-
The handset
battery does
not accept
charge.
• Clean the charging contacts on the cordless handset(s) and
telephone base each month using a pencil eraser or a dry
non-abrasive fabric.
• Make sure the power adapter and telephone line cords are
plugged in correctly and securely.
• Unplug the power adapter. Wait for 15 seconds before
plugging it back in. Allow up to one minute for the cordless
handset and telephone base to reset.
• The telephone might be malfunctioning. Please refer to
the warranty section of this user’s manual for further
instruction.
The CHARGE
light is off.
• First, try all the above suggestions.
• Move the cordless handset closer to the telephone base. It
might be out of range.
• The telephone line cord might be malfunctioning. Try
installing a new telephone line cord.
• Disconnect the telephone base from the telephone jack
and connect a different telephone. If there is no dial tone
on the telephone either, the problem is in your wiring or
local service. Contact your local telephone company.
There is no
dial tone.