Getting started
Remote dial pad registration and de-registration
De-register the remote dial pad
Please read carefully through all the instructions on this page before beginning the de-registration process.
This de-registration de-registers all the items registered to the headset base, including all headsets and the remote dial pad.
1. Press and hold the PAIR button on the headset base until the MUTE light starts to flash, then release the PAIR button.
Flashes
ON/OFF
button
CONNECTING...
NOT REGISTERED
2.Immediately press and release the PAIR button again. You must press the PAIR button while the MUTE light is still flashing. (If the light stops flashing before the dial pad is de-registered, pick up the remote dial pad and place it back into the charger, then start again with step one above.)
3.If the de-registration was successful, the MUTE light on the headset base turns off. The headset(s) ON/OFF light flashes twice every five seconds. The dial pad displays CONNECTING..., then NOT REGISTERED.
NOTE: De-registering the remote dial pad from the headset base also de- registers all the headsets. To use the remote dial pad or the headset again, refer to the registration information on pages 6-7.
