AT&T XG1000 From The Live Video Page You Will Be Able To, Take a Snapshot of the Current Camera

LIVE VIDEO ///

For each discovered camera you will see a Snapshot of the view associated with the camera when you click on the ‘LIVE VIDEO’ tab. This snapshot image is for identifying the camera; it is not updated in real time. The snapshot view for each camera can be refreshed by clicking the ‘REFRESH’ button in the upper right corner of the image. Click on a camera snapshot to view live video from that camera.

FROM THE LIVE VIDEO PAGE YOU WILL BE ABLE TO:

■Take a Snapshot of the Current Camera

■Start or Stop a Live Video

■Arm the Motion Sensor

■Toggle Between Cameras

■Record a Video Clip

The first time you access your Live Video you may be prompted with a pop-up window like the

one below, to install a JAVA plug-in (if you’re using Netscape or Firefox) or ActiveX plug-in (if you’re using Internet Explorer). This plug-in is necessary to view your Live Video. The appearance of the plug-in installer will differ for the two plug-ins, but in both cases you must click ‘YES’ to accept the download for the plug-in. Follow the instructions provided in the INSTALLATION WIZARD for the plug-in. The plug-in will take a few minutes to install.

JAVA INSTALL POP UP WINDOW ACTIVE X INSTALL POP UP WINDOW

If you’re using Netscape or Firefox, you will also be prompted by a security warning, like the one displayed below, when you access your Live Video. Answering ‘ALWAYS’ will prevent this pop-up from being displayed again.

Selecting ‘YES’ will disable the pop up for only that log-in session.

SECURITY WARNING POP UP WINDOW

OPTIMIZING YOUR VIDEO PERFORMANCE:

To ensure that your video performance is optimized you can port forward your router. To do so, please repeat the controller registration process (refer to the instructions, steps 1-4, found on pages 7 and 8 of this manual) where you will be prompted with instructions on port forwarding.

You will be notified during controller registration if your video performance has already been optimized.

USING THE FEATURES IN THE LIVE VIDEO WINDOW:

LIVE VIDEO WINDOW

The Live Video pop-up displays Live Video image along with buttons that will

allow you to start or stop the camera.

You can manually take a snapshot or record a video by clicking the snapshot and

video icons, respectively. Once a Video Clip or Snapshot is taken, they are stored in

the Event Archives section of your account.

Each camera has a built in motion sensor. You can set your camera’s motion sensor to detect motion by using the Arm Motion Sensor checkbox seen below.

You can switch between cameras using the Camera Selection drop-down menu.

9 I0