ACS1208 / ACS1216 User Manual

(Continued from previous page.)

Setting

Function

 

 

SET QUICK

This function lets the Administrator select which Ports to include as

VIEW PORTS

Quick View ports.

 

Š To select/deselect a port as a Quick View Port, Double Click the

 

port you want, or use the Navigation Keys to move the highlight

 

bar to it, then press [Enter].

 

Š When a port has been selected as a Quick View Port, an

 

arrowhead displays in the QV column of the LIST on the Main

 

Screen to indicate so. When a port is deselected, the arrowhead

 

disappears.

 

Š If one of the Quick View options is chosen for the LIST view (see

 

F2 LIST, page 25), only a Port that has been selected here

 

will display on the List.

 

Š If one of the Quick View options is chosen for Auto Scanning

 

(see SCAN/SKIP MODE, page 27), only a Port that has been

 

selected here will be Auto Scanned.

 

The default is for no ports to be selected.

 

 

SET

This function allows the Administrator to define User access to the

ACCESSIBLE

computers on the installation on a Port-by-Port basis.

PORTS

For each User, select the target Port; then press the [Spacebar] to

 

 

cycle through the choices: F (Full access), V (View Only), or blank.

 

Repeat until all access rights have been set, then press [Enter].

 

The default is F for all users on all Ports.

 

Note: A blank setting means that no access rights are granted. The

 

Port will not show up on the User's LIST on the Main Screen.

 

 

RESET STATION

If you change the position of one of the Stations in the daisy chain,

IDS

the OSD settings will no longer correspond to the new situation.

 

This function directs the OSD to rescan the Station positions of the

 

entire installation and updates the OSD so that the OSD Station

 

information corresponds to the new physical layout.

 

Note: Only the Station Numbers get updated. Except for the Port

 

Names, all Administrator settings (such as Set Accessible Ports,

 

Set Quick View Ports, etc.), for all of the computers affected by the

 

change, have to be manually redone.

 

 

FIRMWARE

In order to upgrade the ACS1208 / ACS1216’s firmware (See

UPGRADE

chapter 5), you must first enable Firmware Upgrade Mode with this

 

setting.

 

When you bring up this menu, the current firmware version levels

 

display. Select Y to enable Firmware Upgrade Mode, or N to leave

 

this menu without enabling it.

 

 

30