Port Switching
There are two convenient methods to switch the KVM and Audio focus between the computers: Manual - which involves pressing the pushbutton port selection switches located on the unit’s front panel; and Hotkey - which involves entering combinations from the keyboard.
Manual:
Press the Port Selection switches as follows:
MPress a switch for longer than two seconds to bring the KVM and audio focus to the computer attached to its corresponding port.
MPress a switch for less than two seconds to bring only the KVM focus to the computer attached to its corresponding port.
MPress switches 1 and 2 simultaneously for 3 seconds to start Auto Scan Mode. See p. 10 for details.
Hotkeys:
Key in the hotkey combinations according to the information in the following table:
Hotkey |
| Action | |
[Scroll Lock] [Scroll Lock] | Switches the KVM and audio focus from the port | ||
[Enter] | that currently has the KVM focus to the other port | ||
| (1 to 2; 2 to 1). | ||
| Note that the KVM and audio focus both go to | ||
| this port even if they were on different ports to | ||
| begin with. | ||
|
|
|
|
[Scroll Lock] [Scroll Lock] [K] | Brings only the KVM focus from the port that | ||
[Enter] | currently has it to the other port. The audio focus | ||
| remains where it is. | ||
|
|
|
|
[Scroll Lock] [Scroll Lock] [S] | Brings only the audio focus from the port that | ||
[Enter] | currently has it to the other port. The KVM focus | ||
| remains where it is. | ||
|
|
|
|
| - 9 - |
| |
|
|
|
|
|
|
| |
|
|
|
|