Operation

Hot Plugging

The CS-1262 supports hot plugging - components can be removed and added back into the installation by unplugging and replugging their cables without the need to shut the unit down.

Powering Off and Restarting

If it becomes necessary to Power Off the Master View unit, before starting it back up you must do the following:

1.Shut down all the computers that are attached to the switch.

2.Unplug the switch’s power adapter cable.

3.Wait 10 seconds, then plug the switch’s power adapter cable back in.

4.After the switch is up, Power On the computers.

The Beeper

The CS-1262 beeps to provide information about its operations as follows:

Beeps

Meaning

 

 

1Manual port changes Start of Auto Scan Mode Beeper disabled

2Power On

End of Auto Scan Mode Hotkey port changes Beeper enabled

The Beeper can be toggled off and on with the following hotkey combination:

[Scroll Lock] [Scroll Lock] [B] [Enter]

- 8 -

2005-07-01