Atlantic Technology 10 CSB Painting the Cabinets, Specifications, Subwoofer Troubleshooting Guide

Specifications 11

Instruction Manual

Painting the Cabinets

	The cabinet may be painted to
	blend in even better with your
	room’s décor. First,clean the cab-
	inet,using an appropriate cleaner
	such as non-ammonia Windex®
- -	or diluted Simple Green®. Then
WARNING	use a coat of primer, such as
	Glidden® interior/exterior Grip-
	per® or Rust-Oleum® Rusty
	Metal Primer. Be sure to follow
	the primer’s instructions.

For the finish coat, we recommend using a latex water-based paint.You may use a brush, pad, roller, or spray paint, depending on the type of finish effect desired. For best results apply two light coats of the final color. Make sure the first coat is completely dry before applying the sec- ond coat.

IMPORTANT: Please don’t get paint on the amplifier. Also, don’t paint the driver recess area of the cabinet or risk getting any paint on the acoustical foam or the driver itself, as this may seriously degrade the unit’s performance and void the warranty.

During painting, please protect these areas with paper and mask- ing (painter’s) tape. For best results, remove while the paint is still wet.

Specifications

Type	Sealed enclosure, down-firing
Bass driver	10” (254mm) long-throw
Frequency response	30-250Hz, +/- 3dB
Amplifier power	180 RMS
Peak output	106dB in 2000 cu.ft.
Dimensions (WxHxD)	22 x 19½ x 12”
	559 x 496 x 305mm
Weight	35 lbs (16 kg)

Specifications are those in effect at the time of printing. Atlantic Tech- nology reserves the right to change specifications or designs at any time without notice.

Subwoofer Troubleshooting Guide

Once your subwoofer is set up, you should have many years of maintenance free enjoyment from your system. However, if you should encounter a problem, refer to the following guide to help you find the solution. If a problem persists, you should contact your local authorized Atlantic Technol- ogy dealer.

Problem Possible Cause Possible Solution

No bass output	AC power cord unplugged or
	plugged into a non-working outlet.

Plug into a working outlet.

	Input cables not securely	Check all connections, then try another
	connected or defective.	input cable.
	Receiver/Processor's sub-out is muted,	Check that receiver/processor is configured
	due to incorrect configuration of speaker	so that all speakers are set to "small" and
	setup menu.	sub is "on."
Audible buzz or hum	Input cable not securely connected	Check all connections, then try another
	or defective.	input cable.
	Ground loop through antenna or	Test by disconnecting antenna and/or cable
	cable TV system input.	system input leads. If hum goes away, install
		isolation balun(s) at that point.