Manuals / Brands / Computer Equipment / Network Router / Atlantis Land / Computer Equipment / Network Router

Atlantis Land A02-RAV260-W54 3.4.2 LAN and WAN Port Addresses, 3.5 Information from the ISP, 3.6 Configuring with the Web Browser, IPoA, PPPoE, PPPoA, admin, WAN Port, username, password

1 121

Download 121 pages, 2.66 Mb

VoIPMaster 260W

If you ever forget the password to log in, you may press the RESET button to restore the factory default settings. After turning the router on press the Emergency/Failure Recovery Button on the back of the modem, and hold the button in until all lights on the modem flash and it reboots with factory default settings. The login will be reset to admin and the password will be reset to admin, and the modem will be accessible via its default IP address at http://192.168.1.254/

3.4.2 LAN and WAN Port Addresses

The parameters of LAN and WAN ports are pre-set in the factory. The default values are shown below.

LAN Port			WAN Port

IP address		192.168.1.254	N/A
IP address

Subnet Mask		255.255.255.0
Subnet Mask

DHCP	server	Enabled
function

3.5 Information from the ISP

Before configuring this device, you have to check with your ISP (Internet Service Provider) what kind of service is provided such as PPPoE, PPPoA, RFC1483, IpoA.

Gather the information as illustrated in the following table and keep it for reference.

	PPPoE		VPI/VCI, VC-based/LLC-based multiplexing, Username,
			Password, Service Name, and Domain Name System
			(DNS) IP address (it can be automatically assigned from
			ISP or be set fixed).
	PPPoA		VPI/VCI, VC-based/LLC-based multiplexing, Username,
			VPI/VCI, VC-based/LLC-based multiplexing, Username,
			Password, and Domain Name System (DNS) IP
			address (it can be automatically assigned from ISP or
			be set fixed).

	RFC1483 Bridged		VPI/VCI, VC-based/LLC-based multiplexing and configure
			this product into BRIDGE Mode.
	RFC1483 Routed		VPI/VCI, VC-based/LLC-based multiplexing, IP address,
			Subnet mask, Gateway address, and Domain Name
			System (DNS) IP address (it is fixed IP address).
	IPoA		VPI/VCI, IP address, Subnet mask, Gateway address,
			and Domain Name System (DNS) IP address (it is fixed
			IP address).

3.6 Configuring with the Web Browser

Open the web browser, enter the local port IP address of this ADSL2+ VOIP Router, which defaults at http://192.168.1.254, and click “Go”, a username and password window will appear. The default username & password are admin & atlantis, in respectively

22

Contents

USER’S MANUAL Where solutions begin Page Copyright Disclaimer CAUTION CHAPTER CHAPTER CHAPTER APPENDIX A APPENDIX B APPENDIX C APPENDIX D Introduction Quality of Service and IP Throttling Easy Configuration and Management 1.2 Package Contents If any of the above items are missing, please contact your reseller 1.3 ADSL2+ VOIP Router Features ADSL Multi-Mode Fast Ethernet Switch: 802.11g Wireless AP with WPA Support: Multi-Protocol to Establish A Connection: Quick Installation Wizard: QoS: Domain Name System (DNS) relay: Dynamic Domain Name System (DDNS): PPP over Ethernet (PPPoE): Virtual Server: Web based GUI: Firmware Upgradeable: Rich management interfaces: Page Using ADSL2+ VOIP Router 2.1 Cautions for using the ADSL2+ VOIP Router 2.2 The Front LEDs LED Meaning 2.3 The Rear Ports PORT Antenna (R-SMA) ADSL (RJ11) LINE (RJ11) 2.4 Cabling LED ADSL A01-AF2 2.4.1 Connecting your router Page ADSL Led Configuration, WAN Connection Mode Apply Save Config to Flash Configuration For Windows 95/98/ME DNS Configuration Disable DNS “OK” For Windows NT4.0 For Windows Page For Windows XP Page 3.3.1 Configuration Check 3.4.1 Username and Password 3.4.2 LAN and WAN Port Addresses 3.6.1 STATUS vance 3.6.1.1 ARP Table 3.6.1.2 Wireless Association Table (Wireless Router only) 3.6.1.3 Routing Table 3.6.1.4 DHCP Table 3.6.1.5 Email Status 3.6.1.6 VoIP Status 3.6.1.7 Event Log 3.6.1.8 Error Log 3.6.1.9 NAT Sessions 3.6.1.10 Diagnostic 3.6.1.11 UPnP Portmap 3.6.2 Quick Start Guide Start 3.6.3 CONFIGURATION 3.6.3.1 LAN 3.6.3.1.1 Bridge Filtering Bridge Interface VLAN Port (Always starts with) 3.6.3.1.2 Ethernet 3.6.3.1.3 IP Alias 3.6.3.1.4 Ethernet Client Filter Page 3.6.3.1.5 Wireless ESSID Broadcast: Enable Disable: Enable: Regulation Domain: 3.6.3.1.6 Wireless Security WPA Shared Key: Group Key Renewal: WEP: WEP Encryption: WEP 64 and WEP 3.6.3.1.7 Wireless Client (MAC Address) 3.6.3.1.8 Port Setting 3.6.3.1.9 DHCP Server Disabled Next Apply DHCP Server Next Starting IP Address: Ending IP Address: Defaul Lease Time: Use Router as DNS Server Primary/Secondary DNS Server Address 3.6.3.2 WAN 3.6.3.2.1 ISP PPPoE(RFC 2516) or PPPoA(RFC 2364) Service Name: Authentication Protocol Type: Always on: Connect to Demand: Idle Timeout: RFC 1483 Routing or IPoA routed(RFC1577) BRIDGE (PPPoE) 3.6.3.2.2 DNS 3.6.3.2.3 ADSL 3.6.3.3 SYSTEM 3.6.3.3.1 Time Zone 3.6.3.3.2 Remote Access 3.6.3.3.3 Firmware Upgrade 3.6.3.3.4 Backup/Restore 3.6.3.3.5 Restart 3.6.3.3.6 User Management Page 3.6.3.4 FIREWALL 3.6.3.4.1 General Settings Page 3.6.3.4.2 Packet Filering Add Raw IP Filter: Packet Filter Rules: Delete Rule Name: Time Schedule: Protocol Number: 3.6.3.4.3 Intrusion Detection Page 3.6.3.4.4 Url Filtering Domains Filtering Restrict URL Features: Example: 3.6.3.4.5 Firewall Log 3.6.3.5 VOIP 3.6.3.5.1 Wizard 3.6.3.5.2 General Settings Outbound Proxy Port: How to register to SIP Server 3.6.3.5.3 Phone Ports Codec Preference G.729: G.711 -LAW: G.711A-LAW: 3.6.3.5.4 PSTN Dial Plan -Power down Internet Service fail -SIP service is not accessible. This excludes when: PSTN Dial Plan Examples: 1)Dial with Prefix 2)Dial without Prefix 3)Dial at Timeout 4)Dial at Timeout no Prefix Page 3.6.3.5.5 VoIP Dial Plan Dial Plan Rules List Prefix Processing: Prepend xxx unconditionally: If Prefix is xxx, delete it: If Prefix is xxx, replace with: Here are some Examples for your reference: Main Digit Sequence Lists: Description 3.6.3.5.6 Ring & Tone Option Flash-hook *69 *20 *80 Page 3.6.3.6 QoS 3.6.3.6.1 Prioritization Source IP Address Range Destination IP address Range DSCP Marking 3.6.3.6.2 Outbound IP Throttling (LAN to WAN) 3.6.3.6.3 Inbound IP Throttling (WAN to LAN) 3.6.3.6.4 Example: QoS for your Network Mission-criticalapplication Voice application Restricted Application Advanced setting by using IP throttling Page 3.6.3.7 Virtual Server Edit DMZ Host One-to-OneNAT (Network Address Translation) Global IP: Global IP Address nternal IP Address: 3.6.3.8 TIME SCHEDULE Day: Start Time: End Time: Delete a Time Slot Clear 3.6.3.9 ADVANCED 3.6.3.9.1 Static Route 3.6.3.9.2 Dynamic DNS 3.6.3.9.3 Check Emails 3.6.3.9.4 Device Management Embedded Web Server Universal Plug’n’Play SNMP Access Control 3.6.3.9.5 IGMP 3.6.3.9.6 VLAN Step 2: Create WAN Interface Go to Configuration Æ WANÆ ISP wanlink RFC 1483 Bridged Pppoe Step 3: Setup VLAN Service Go to Configuration Æ Advanced Æ VLAN Bridge DefaultVlan Create VLAN VLAN Bridge 3.6.4 Save Config To Flash 3.6.5 Logout Troubleshooting QuestionAnswer The past: Yesterday: Today: The future: What is How does it work What is VoIP What is the advantages using VoIP rather PSTN Then, why everybody doesn't use it yet What is SIP Does VoIPMaster 260W support H.323 Does my computer have to be turned on How to make a call with remove IP address only, not through SIP server Which VoIP Providers can support theVoIPMaster 260W Can I use the DDNS to make a voice connection What is STUN Specifications Traffis Shaping VoIP Provider Mitel Support