Error Messages:
Display | Error Description | ||
|
| A short circuit has been detected on the programming track. | |
E |
| ||
| Check relevant connections and/or decoder installation in the | ||
| locomotive. | ||
|
| No value was found during the readout of a Register, or no | |
E | 2 | ||
response was received after a value was entered. However, this | |||
does not necessarily mean the decoder did not accept the new | |||
values. Please try using the new address before attempting to program again. You should also check if the locomotive is on the right programming track and/or the installation of the decoder.
System Settings
The following system parameters can be edited or viewed:
•Version number of the Commander software (view only).
•Service number of the Commander. You will be asked to identify this number if you call in for assistance with your Commander.
•If your Commander is set to function as a master or as a slave (also called an XpressNET unit).
1. Press both |
|
| and |
| buttons at the same time to access the Menu system. | |||
|
|
| ||||||
| ||||||||
|
| Use the "+" | or | |||||
|
| Display |
| What To Do | ||||
|
| SY.S |
| Press Enter to select the System mode setting. | ||||
|
|
| ||||||
|
| . |
|
|
| The first system setting (shown to left) is the Commander | ||
|
|
|
| |||||
|
|
|
|
| ||||
|
| Y |
| software version number setting option. | ||||
|
|
|
|
|
| |||
|
|
|
|
|
|
|
|
|
|
|
| Press Enter to view the version number. You cannot |
| . |
| change this value; it is |
|
| System menu. | |
|
|
| |
Y | 2 |
| Press +/- buttons until you see the service number system |
| setting option (shown on left). | ||
|
|
| Press Enter to view the service number. You cannot |
| 02 |
| |
|
| change this value; it is | |
|
| System menu. | |
| . |
| Press "+" or |
|
| ||
Y 9 0 |
| setting (shown on left). Press Enter to select setting options. | |
|
|
| Press "+" or |
|
|
| |
|
|
| your Commander operate in master mode, press Enter when |
|
|
| you see the display on left. |
To have your Commander operate in slave mode, press Enter when you see display on left. Press Exit to leave the menu.
EXPANDING YOUR SYSTEM
Adding Additional Throttles
If you would like to have more than one operator on your layout, you may connect up to five additional Commanders or handhelds that conform to XpressNET standards to your original unit. When you have more than one Commander, one becomes the "master" and the other(s) become "slaves." The master provides track power, the slaves do not. Any Commander (master or slave) that is connected to a Generator may be used for programming. In the case of a slave that is used for programming, it must be connected to a pro- gramming track via output terminals P & Q and must be connected to a
15 | 16 |
