4/11
AtlasSound.com
TELEPHONE: (800) 876-3333
FAX (800) 765-3435
©2012 Atlas Sound L.P. All rights reserved. Atlas Sound is a trademark of Atlas Sound L.P. All other trademarks are the property of their respective owners. All specs are subject to change without notice. ATS004338 RevA 5/12
AH Series Loudspeakers
8", 12", and 15"
1601 JACK MCKAY BLVD.
ENNIS, TEXAS 75119 U.S.A.

Installation Via Mounting Bracket (Included)

General considerations and hardware recommendations
CAUTION: AH series models weigh as much as 81 pounds (36.7kg) – model AH5040CD. A fall from almost any height could result in serious
injury or death. Assure that the speaker is firmly mounted to an object that can handle the weight of the AH speaker. Remember that wind will add
considerable torque to the point of attachment. The mounting surface the AH speaker is being attached to should be able to handle five or more times
the weight of the AH speaker (7x recommended for locations subject to high wind forces).
Whenever the loudspeaker is mounted to a surface using the bracket, the installer must ensure that the surface is capable of safely and securely
supporting the load. The hardware employed must be safely and securely attached both to the loudspeaker and the surface in question, using only the
mounting holes. A general rule for soft surface installations (wood beams) is to multiply the corresponding working load limit by 75%; the result will
be an approximate working load strength.
Use thread locking compound for all installations.
CAUTION: Mount the speaker such that the shear force is at a right angle to the mounting bolts, and close to the connection, as shown:
When mounting the AH speaker to a solid surface use the proper bolts, washers, and lock washers (Grade 5 minimum). Do not substitute mismatched
bolts and washers.
The AH speaker may be mounted to a pole or scoreboard. For such mounting, contact the light pole or scoreboard manufacturer for proper
instructions. If mounting to another surface, such as a beam, see the diagram on page seven for mounting hole locations. When in doubt contact a
qualified structural/mechanical engineer for approval of the mounting materials and methods.
SHEAR FORCE
Lock Washer
TENSION FORCE
Flat Washer