Juniper Networks M160 manual Installing the CIP, Removing the CIP

Replacing Hardware Components

Figure 64: Removing the CIP

1260

Installing the CIP

To install the CIP, follow this procedure (see Figure 65):

1.Verify that the router is powered down.

2.Carefully insert the rear of the CIP into the guides at the top and bottom of the CIP slot, which is located to the left of the FPC card cage.

NOTE: The components on the CIP are on the left side of the board, unlike the components of an FPC, which are on the right side. Verify that the components are on the left before inserting the CIP.

3.Slide the CIP into the chassis until it contacts the midplane.

Replacing the CIP and Routing Engine Interface Port Cables 143