Juniper Networks M160 manual Installing the CIP

M160 Internet Router Hardware Guide

CAUTION: Be sure to slide the CIP straight within the slot to avoid damaging the connector pins on the front of the midplane.

4.Using a Phillips screwdriver, tighten the screw at each end of the CIP faceplate.

5.Reattach an external management device to one of the Routing Engine ports on the CIP (AUXILIARY, CONSOLE, or ETHERNET). Also reattach alarm relay contacts if desired. For instructions, see “Replacing the Management Ethernet Cable” on page 146, “Replacing the Console or Auxiliary Cable” on page 146, and “Replace Alarm Relay Wires” on page 147.

6.Power on the router and verify correct startup by performing the procedures in “Powering On the Router” on page 119.

Figure 65: Installing the CIP

1259

144 Replacing the CIP and Routing Engine Interface Port Cables