Juniper Networks M160 manual Reinstalling the Fan Tray, Reinstalling an FPC

M160 Internet Router Hardware Guide

5.Align the rear bottom corners of the FPC with the guides at the bottom of the FPC slot. Slide the FPC into the card cage until it contacts the midplane.

6.Push the ends of the ejector levers inward until they are nearly flush with the face of the FPC.

7.Tighten the thumbscrew at each end of the FPC to seat the FPC securely in the chassis.

8.Repeat the procedure for each FPC, proceeding from left to right through the slots with offline buttons labeled FPC1 through FPC7 on the craft interface.

Figure 46: Reinstalling an FPC

Ejector levers

1193

Reinstalling the Fan Tray

The fan tray, which includes the cable management system, is located on the front of the chassis, just above the air filter, as shown in Figure 1. To reinstall it, follow this procedure (see Figure 47):

102 Reinstalling Components into the Chassis