Juniper Networks M160 manual Cable Connector Pinouts, RJ-45 Connector Pinout Signal

Appendix C

Cable Connector Pinouts

This chapter describes the pinouts for the following cable connectors:

RJ-45 Connector Pinouts for the Routing Engine ETHERNET Port on page 269

DB-9 Connector Pinouts for the Routing Engine AUXILIARY and CONSOLE

Ports on page 270

RJ-48 Cable Pinouts for E1 and T1 PICs on page 270

X.21 and V.35 Cable Pinouts for EIA-530 PIC on page 273

Fast Ethernet 48-port Cable Pinouts on page 274

RJ-45 Connector Pinouts for the Routing Engine ETHERNET Port

The port on the CIP labeled ETHERNET is an autosensing 10/100-Mbps Ethernet RJ-45 receptacle that accepts an Ethernet cable for connecting the Routing Engine to a management LAN (or other device that supports out-of-band management). For more information, see “Routing Engine Management Ports” on page 33. Table 28 describes the RJ-45 connector pinout.

Table 28: RJ-45 Connector Pinout

Pin

1

2

3

4

5

6

7

8

Signal

TX+

TX-

RX+

Termination network

Termination network

RX-

Termination network

Termination network

RJ-45 Connector Pinouts for the Routing Engine ETHERNET Port 269