Juniper Networks M160 manual LCD Alarm Mode, LCD in Idle Mode

M160 Internet Router Hardware Guide

Figure 12: LCD in Idle Mode

MENU

Router1

Up 2 + 11:59

ENTER

Power OK

1263

The lines in the display report the following information:

First line—Routing node name.

Second line—Length of time the router has been running, reported in the following form:

Up days + hours : minutes

Third and fourth lines—Status messages, which rotate at two-second intervals. Some conditions, such as removal or insertion of a system component,

can interrupt the messages.

To add a message that alternates every 2 seconds with the default status messages, use the set chassis display message command. For more information, see the JUNOS Internet Software Operational Mode Command Reference: Protocols, Class of Service, Chassis, and Management.

LCD Alarm Mode

When a red or yellow alarm occurs, the LCD switches to alarm mode and reports about the alarm condition, as shown in Figure 13.

Figure 13: LCD in Alarm Mode

MENU

ENTER

Router1 2

R:PEM 1 Input Failure

Y:Change air filter

1264

30 Craft Interface