Juniper Networks M160 manual Powering On the Router, Connecting Power and Grounding Cables

Connecting the Router and Performing Initial Configuration

Connect the positive (+) source cable lugs to the return terminals, which are labeled RTN(+).

Connect the negative (–) source cable lugs to the input terminals, which are labeled –48V.

10.Install another washer and nut (in that order) on each terminal stud to secure the power cable lug. Using a 7/16-in. nut driver or wrench, tighten the nuts.

11.Verify that the source power cabling and the grounding cabling are correct, that they are not touching or blocking access to router components, and that they do not drape where people could trip on them.

12.Replace the protective shield over the terminal studs and use a Phillips screwdriver to tighten the screws.

Figure 60: Connecting Power and Grounding Cables

Nut

Flat washer

Nut

Flat washer

Cable lug

Terminal studs

Grounding points

To ground

g001226

Powering On the Router

To power on the router, follow this procedure:

1.Verify that the power supplies are fully inserted in the chassis and the thumbscrews on their faceplates are tightened.

Providing Power to the Router 119