Juniper Networks M160 manual Maintaining Packet Forwarding Engine Components

M160 Internet Router Hardware Guide

Background	0	percent
Kernel	0	percent
Interrupt	0	percent
Idle	100	percent
Model		RE-2.0
Serial ID		6d000007c8150801
Start time		2003-04-22 10:01:29 PDT
Uptime		16 days, 3 hours, 6 minutes, 34 seconds

Issue the CLI show chassis environment mcs command to check the status of the MCSs. As shown in the sample output, the MCS that belongs to the master host module is designated Master in the State field:

user@host> show chassis environment mcs

MCS 0 status:
State			Online Master
Temperature		48	degrees C / 118 degrees F
Power:
3.3	V	3299	mV
5.0	V	4971	mV
12.0 V		11770	mV
5.0	V bias	4989	mV
8.0	V bias	8246	mV
BUS Revision		12
FPGA Revision		13
MCS 1 status:
State			Online Standby
Temperature		51 degrees C / 123 degrees F
Power:
3.3V		3316	mV
5.0	V	5001	mV
12.0 V		11775	mV
5.0	V bias	5001	mV
8.0	V bias	8249	mV
BUS Revision		12
FPGA Revision		13

For further description of the output from the commands, see the JUNOS Internet Software Operational Mode Command Reference: Protocols, Class of Service, Chassis, and Management.

Maintaining Packet Forwarding Engine Components

For instructions on maintaining Packet Forwarding Engine components, see the following sections:

Maintaining FPCs on page 133

Maintaining PICs and PIC Cables on page 134

Maintaining the PCGs on page 135

132 Maintaining Packet Forwarding Engine Components