dSwap the memory module in socket 1 with another of the same capacity. See "Installing Memory Modules" on page 77.
eRotate the
fClose the system. See "Closing the System" on page 43.
gReconnect the system to its electrical outlet, and turn on the system and attached peripherals.
hAs the system boots, observe the monitor screen and the indicators on the keyboard.
13Perform the following steps:
a Turn off the system and attached peripherals, and disconnect the system from its electrical outlet. b Open the system. See "Opening the System" in "Installing System Components."
c Rotate the
d Repeat step d through step h in step 12 for each memory module installed. If the problem persists, see "Getting Help" on page 123."
Troubleshooting a Diskette Drive
Problem
•Error message indicates a diskette drive problem.
Action
CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. Before performing any procedure, see your Product Information Guide for complete information about safety precautions, working inside the computer and protecting against electrostatic discharge.
1Enter the System Setup program and verify that the diskette drive is configured correctly. See "Using the System Setup Program" on page 27.
2Run the appropriate online diagnostic test. See "Using Dell PowerEdge Diagnostics" on page 113.
3Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.
4Open the system. See "Opening the System" on page 43.
5Ensure that the diskette drive interface cable is securely connected to the diskette drive and the system board.
6Ensure that a power cable is properly connected to the drive.
7Close the system. See "Closing the System" on page 43.
8Reconnect the system to the electrical outlet, and turn on the system and attached peripherals.
9Run the appropriate online diagnostic test to see whether the diskette drive works correctly.
Troubleshooting Your System
