Delta Electronics VFD-EL B.8.4.4 LED Indicator Explanation & Troubleshooting, MAC ID Setting

Appendix B Accessories

Example: If you need to set up the communication speed of CME-COP01 as 500K, simply

switch BR to “5”.

BR Value	Baud rate	BR Value
0	10K	4
1	20K	5
2	50K	6
3	125K	7

Baud rate

250K

500K

800K

1M

MAC ID Setting

Rotary switches (ID_L and ID_H) set up the Node-ID on CANopen network in hex. Setup range: 00 ~ 7F (80 ~FF are forbidden)

	6	7		8	9	A
5
						B
4						C
3						D
	2		1	0 F		E

ID_H

	6	7		8	9	A
5
						B
4							C
3							D
	2		1	0 F		E

ID_L

Example: If you need to set up the communication address of CME-COP01 as 26(1AH), simply switch ID_H to “1” and ID_L to “A”.

Switch Setting	Content
0 … 7F	Valid CANopen MAC ID setting
Other	Invalid CANopen MAC ID setting

B.8.4.4 LED Indicator Explanation & Troubleshooting

There are 3 LED indicators, RUN, ERROR and SP, on CME-COP01 to indicate the communication status of CME-COP01.

RUN LED

LED Status	State	Indication
OFF	No power	No power on CME-COP01 card
Single Flash	STOPPED	CME-COP01 is in STOPPED state
(Green)
Blinking	PRE-OPERATIONAL	CME-COP01 is in the PRE-
(Green)		OPERATIONAL state
Green ON	OPERATIONAL	CME-COP01 is in the
		OPERATIONAL state
Red ON	Configuration error	Node-ID or Baud rate setting error

Revision August 2008, 2ELE, V1.02 B-23