Delta Electronics VFD-EL manual Trial Run, Frequency Source, Method

				Chapter 3 Keypad and Start Up
Operation	Frequency Source				Operation Command Source
Method
Operate from	When setting communication by the PC, it needs to use VFD-USB01 or IFD8500
the	converter to connect to the PC.
communication	Refer to the communication address 2000H and 2101H setting for details.
			FWD/Stop			+24V
	Factory setting:					MI1
			REV/Stop
	NPN Mode					MI2
	NPN	Factory	Multi-step 1			MI3
	Sw1	setting	Multi-step 2			MI4
	PNP		Multi-step 3
						MI5
			Multi-step 4
						MI6
			Digital Signal Common
						DCM
		* Don't apply the mains voltage directly				E
Operate from		to above terminals.				+10V
external signal
	Factory setting:			3		Power supply
						+10V 3mA
	ACI Mode		5K	2		AVI
	AVI
						Master Frequency
	Sw2			1
						0 to 10V 47K
	ACI					ACI/AVI
						4-20mA/0-10V
						ACM
			Analog Signal Common			E
	MI3-DCM (Set Pr.04.05=10)				External terminals input:
					MI1-DCM (set to FWD/STOP)
	MI4-DCM (Set Pr.04.06=11)
					MI2-DCM (set to REV/STOP)
Operate from
the digital
keypad

3.5 Trial Run

You can perform a trial run by using digital keypad with the following steps. by following steps

1.Setting frequency to F5.0 by pressing .

2.If you want to change direction from forward running to reverse running: 1. press MODE key to find FWD. 2. press UP/DOWN key to REV to finish changing direction.

Revision August 2008, 2ELE, V1.02 3-5