Delta Electronics VFD-EL When Pr.02.07 is set to 2 increase/decrease the frequency by Pr.02.08

Chapter 4 Parameters

These parameters determine the increase/decrease of the master frequency when operated via the Multi-function Inputs when Pr.04.05~Pr.04.08 are set to 10 (Up command) or 11 (Down command).

When Pr.02.07 is set to 0: increase/decrease the frequency by using UP/DOWN key. It is valid only when the AC motor drive is running.

When Pr.02.07 is set to 1: increase/decrease the frequency by acceleration/deceleration settings. It is valid only when the AC motor drive is running.

When Pr.02.07 is set to 2: increase/decrease the frequency by Pr.02.08.

When Pr.02.07 is set to 3: increase/decrease the frequency by Pr.02.08 (unit: pulse input).

02.11	Keypad Frequency Command		Unit: 0.01
	Settings	0.00 to 600.0Hz	Factory Setting: 60.00
This parameter can be used to set frequency command or read keypad frequency command.
02.12	Communication Frequency Command		Unit: 0.01
	Settings	0.00 to 600.0Hz	Factory Setting: 60.00

This parameter can be used to set frequency command or read communication frequency command.

02.13The Selections for Saving Keypad or Communication Frequency Command

Factory Setting: 0

Settings	0	Save Keypad & Communication Frequency
	1	Save Keypad Frequency only
	2	Save Communication Frequency only

This parameter is used to save keypad or RS-485 frequency command.

02.14Initial Frequency Selection (for keypad & RS485)

				Factory Setting: 0
	Settings	0	By Current Freq Command
		1	By Zero Freq Command
		2	By Frequency Display at Stop
02.15	Initial Frequency Setpoint (for keypad & RS485)			Unit: 0.01
	Settings	0.00 ~ 600.0Hz		Factory Setting: 60.00

4-44 Revision August 2008, 2ELE, V1.02