Figure 3-4. Rotating the Hard-Drive Carrier Out of and Into the System
| 2 |
1 | 3 |
|
1 rotatable | 2 | handle | 3 |
Rotating the Hard-Drive Carrier Into the System
1Grasp the handle on the
2Pull up on the card retention mechanism to release it from the
3Rotate the card retention mechanism back into its original position; push its tip so that its tab clicks into place. See Figure
4Reconnect the P3
Removing and Replacing the Front Drive Bezel
CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. Before performing any procedure, see your Product Information Guide for complete information about safety precautions, working inside the computer and protecting against electrostatic discharge.
1Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.
2Open the system. See "Opening the System" on page 43."
NOTE: This sliding plate secures and releases the drive bezel and helps to secure the drives.
3Pull the lever on the sliding plate to the right until it releases the front drive bezel from its side hinges.
46