3Unpack the replacement diskette drive, and prepare it for installation.
4Check the documentation for the drive to verify that it is configured for your system.
5Attach the four shoulder screws to the drive as shown in Figure
NOTE: Spare shoulder screws are attached to the inside of the front drive bezel.
6Remove the front drive bezel. See "Removing and Replacing the Front Drive Bezel" on page 46.
Figure 3-17. Installing Diskette Drive Shoulder Screws
1
1 screws (4)
7Remove the front drive bezel insert. See "Removing and Replacing the Front Drive Bezel Insert" on page 47.
8From the front of the chassis, slide the drive into the drive bay until the shoulder screws snap securely into the sliding plate.
9Connect the power cable to the drive. See Figure
10Connect the interface cable from the drive to the DSKT connector on the system board. See Figure
11Close the system. See "Closing the System" on page 43.
12Replace the front drive bezel. See "Removing and Replacing the Front Drive Bezel" on page 46.
13Reconnect the system to the electrical outlet, and turn on the system and attached peripherals.
14Enter the System Setup program and ensure that the drive’s controller is enabled. See "Using the System Setup Program" on page 27.
15(Optional) Test the drive by running the system diagnostics. See "Running the System Diagnostics" on page 113.
Installing System Components
65