Dell SC1430 owner manual Drive missing, Configuration, Location, Resource conflict, System board

Table 1-6. System Messages (continued)

Message	Causes	Corrective Actions
General failure	The operating system is unable to	This message is usually followed by
	carry out the command.	specific information. Note the
		information and take the appropriate
		action to resolve the problem.
IDE primary drive n not	IDE cables are not properly seated, or	See "Troubleshooting an Optical Drive"
found	drive missing.	on page 106.
Invalid configuration	System has detected invalid	Remove the RTCST jumper if it is
information - please run	configuration.	installed. See Figure 6-1 for the jumper
SETUP program		location.
Invalid NVRAM	System detected and corrected a	No action is required.
configuration, Resource	resource conflict.
Re-allocated
Keyboard Controller	Faulty keyboard controller; faulty	See "Getting Help" on page 123.
failure	system board
Manufacturing mode	System is in manufacturing mode.	Reboot to take the system out of
detected		manufacturing mode.
MEMBIST failure - The	Faulty memory module(s).	See "Troubleshooting System Memory"
following DIMM/rank has		on page 103.
been disabled by BIOS:
DIMM x Rank y
Memory address line	Faulty or improperly installed memory	See "Troubleshooting System Memory"
failure at address, read	modules.	on page 103.
value expecting value
Memory double word logic
failure at address, read
value expecting value
Memory odd/even logic
failure at address, read
value expecting value
Memory write/read failure
at address, read value
expecting value
Memory tests terminated by	POST memory test terminated by	Information only.
keystroke.	pressing the spacebar.

About Your System

21