Figure 3-18. Removing and Installing an Optical or Tape Drive
2
3
4
1
5
1 | drive bay sliding plate | 2 | interface cable | 3 | power cable |
4 | SATA cable | 5 | IDE connector |
|
|
NOTICE: If metal shields are present, they must be installed at all times while your system is in use or your system may not function properly.
6If you are not installing another drive in the bay, install the
7If you are installing another drive in the bay, see "Installing an Optical or Tape Drive" on page 68.
8If the drive is being permanently removed, install a front drive bezel insert. See "Removing and Replacing the Front Drive Bezel Insert" on page 47.
9Replace the front drive bezel. See "Removing and Replacing the Front Drive Bezel" on page 46.
10Close the system. See "Closing the System" on page 43.
11Reconnect the system to the electrical outlet, and turn on the system and attached peripherals.
Installing System Components
67