Figure 3-16. Removing or Installing a Diskette Drive
2
3
1
4
1 | drive bay sliding plate | 2 | interface cable | 3 | power cable |
4 | DSKT connector |
|
|
|
|
7If the drive is being permanently removed, install a front drive bezel insert. See "Removing and Replacing the Front Drive Bezel Insert" on page 47.
8Replace the front drive bezel. See "Removing and Replacing the Front Drive Bezel" on page 46.
9Close the system. See "Closing the System" on page 43.
10Reconnect the system to the electrical outlet, and turn on the system and attached peripherals.
Installing a Diskette Drive
CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. Before performing any procedure, see your Product Information Guide for complete information about safety precautions, working inside the computer and protecting against electrostatic discharge.
1Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.
2Open the system. See "Opening the System" on page 43.
64
