Opening the System
CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. Before performing any procedure, see your Product Information Guide for complete information about safety precautions, working inside the computer and protecting against electrostatic discharge.
1Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.
2Press the power button to ground the system board.
3If you have installed a padlock through the padlock ring on the back panel, remove the padlock.
4Lay the system on its side as shown in Figure
5Open the system by sliding the cover release tab toward the rear of the system and lifting off the cover.
Closing the System
1Ensure that all internal cables are connected and folded out of the way.
2Ensure that no tools or extra parts are left inside the system.
3Reinstall the system cover:
a Insert the bottom edge of the cover into the bottom of the system chassis. See Figure
4If applicable, install the padlock.
5Reconnect the system to the electrical outlet, and turn on the system and attached peripherals.
After you open and close the cover, the chassis intrusion detector, if enabled, causes the following message to appear on the screen at the next system
ALERT! Cover was previously removed.
6To reset the chassis intrusion detector, press <F2> to enter the System Setup program. See "Using the System Setup Program" on page 27.
NOTE: If a setup password has been assigned by someone else, contact your network administrator for information on resetting the chassis intrusion detector.
Installing System Components
43