Power Supply
Removing the Power Supply
CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. Before performing any procedure, see your Product Information Guide for complete information about safety precautions, working inside the computer and protecting against electrostatic discharge.
1Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.
2Open the system. See "Opening the System" on page 43.
3Rotate the
4Disconnect the DC power cables from the system board (POWER1 and POWER2), the drives, and any other cards or devices to which they are connected.
NOTE: Note the routing of the DC power cables underneath the tabs in the system frame as you release the tabs and remove the cables from the system board and drives. You must route these cables properly when you replace them to prevent their being pinched or crimped.
5Using a #2 Phillips screwdriver, remove the four Phillips screws that secure the power supply to the back panel.
6Press the
Installing System Components
81