RECOMMENDED POWER AIR INLET SYSTEM
M105
40
Your ARO | tool | is designed | todeliver | specific horsepowerand | thrust toachieve | high rates of work. To assure the unit will develop this |
| ||||||||
power, | care | must | be taken that | the power | air | Inlet | system Is correctly | sized to permit | the proper rate of air | flow. | Shown above is asystem for | a | |||
single tool that will supply correct dellvery. |
|
|
|
|
|
|
|
| |||||||
IMPORTANT: | The tool is | when 90 p.s.i. is present atthe tool during operation. To check operating | air pressure atthe tool, apressure |
| |||||||||||
gauge | may | be installed | in a 1/8” | n.p.t. | port | marked | “Auxiliary Supply”. | CAUTION: This | port | Is pressurized | when | tool Is connected toair supply. |
| ||
Shown below Is the same system in schematic form.
If two units are to be Installed, each unit should be supplied with a system like that shown below or use two systems Iike that above.
15
