10 
DISASSEMBLY INSTRUCTIONS
<"Terminal with locking mechanism" Detaching points>
The terminal which has the locking mechanism can be detached as shown below. There are two types ( Refer to (1) and (2)) of the terminal with locking mechanism. The terminal without locking mechanism can be detached by pulling it out.
Check the shape of the terminal before detaching.
(1) Slide the sleeve and check if there is a locking lever or not.
Sleeve
1Slide the sleeve.
2Pull the terminal while
Locking lever 
pushing the locking lever.
(2)The terminal with this connector has the locking mechanism.
1Hold the sleeve, and pull out the terminal slowly.
Connector
INDOOR UNIT
MSZ-FA35VA - E1
| OPERATING PROCEDURE | PHOTOS |
1. Removing the panel | Photo 1 | |
(1) | Press and unlock the knobs on both sides of the front |
|
| panel and lift the front panel until it is level, and then pull | Front panel |
| the hinges forward to remove the front panel. | |
|
| |
(2) | Remove the horizontal vane. |
|
(3) | Remove the screw caps of the panel. |
|
| Remove the screws. (See Photo 1.) |
|
(4) | Remove the screw of the front panel driving motor. |
|
| (See Photo 2.) |
|
(5)Hold the lower part of both ends on the panel and pull it slightly toward you, and then remove the panel by pushing it upward.
Screws of the panel
Horizontal vane
Photo 2
Screw of the front panel driving motor
31
