Atlas Sound TSD-MIX41 owner manual Rear Panel Description

TSD-MIX41

4x1 Mic/Line Mixer

Owner’s Manual

Rear Panel Description

4	4
	3
4	4

12

TSD Input/Output connections are removable for easy system wiring. The connector has a 3.5mm pitch between pins.

1.DC Power Input - Each TSD that requires DC power comes with a 2 position connector for

an external 24VDC power supply (sold separately). Because of the TSD’s low power consumption, a single external power supply may power more than one TSD. Please refer to the specifications on current requirements in milliamps to match with the appropriate power supply. Note: It is acceptable to exceed the current requirements of the TSDs but NOT safe to use a power supply that is below the current requirement of the device.

2.Balanced Inputs 1-4- Connects to balanced line or mic level sources. Your connection must be mated properly to the input connector or signal loss and/or noise may occur. For gain or source input type selection, refer to the “Dip Switch Function Identification” chart for proper input setting. Note: Unbalanced line level inputs can be inserted with proper wire configuration by connecting the (G) and (-) terminals together.

3.Balanced Line Output - Provides output when an input signal is present for connection to balanced line level devices. Your output connections must be connected properly to the connectors or loss and/or noise may be introduced into the signal. Note: Unbalanced line level devices can be used with proper wire configuration by connecting the (G) and (-) terminals together.

4.Cable Management Retainer Points - Each TSD includes two cable retainer straps for securing the included cable management retainers. Remove one of the rear panel screws, align the panel hole with a retainer and firmly tighten the screws.

1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A.

Telephone: 800.876.3333 • Fax: 800.765.3435

AtlasSound.com – 4 –

Specifications are subject to change without notice.