CONNECTION DIAGRAM
CAT5/6/7 cable
up to 330ft
RS232 cable
Transmitter
DVI cable
IR Emitter
RS232 cable
OR
IR Remote
Receiver
DVI cable
IR Bug
The
Therefore the IR and or RS232 signal could be send from the remote location to main hub or from control system to the remote location.
TROUBLESHOOTING
1. No Video Signal on the Display or Signal is going in and Out:
a. Please test your RJ45 cables with a Fluke or similar tester to make sure that all the wires are connected and the distance is within the limits.
b. If you are using patch panel or and RJ45 wall plates, the distance will be reduced, please do a direct connection by passing all additional equipment.
c. Please try to
d. If your sources is a computer (laptop or desktop), please enable the DVI output.
•Windows computers: Select Properties 
Select Display resolutions 
Select Detect Display 
Select second Display 
Select Extended Display check box 
Select most appropriate resolution (most basic would be 1024x768)
•Mac Computers: Select Settings 
Select Displays 
Select Detect Display 
Select Arrangement 
Select Mirror Displays 
Select most appropriate resolution (most basic would be 1024x768)
2. IR Signal is not passing through:
Make sure you have IR RX and IR TX connected to its respective interfaces. If not, you may have burned the IR sensor on the IR RX or and IR TX and therefore should replace them.
Toll free: | 5 | www.atlona.com |
Local: |
