Atlona AT-H2H-88M

---> ---> --->

--->---> --->

AT-H2H-88M

Select Input Number

Select output number

(1-8) to set ARC mode

Output: # Current: On

Select mode 1: On 2: Off

Output: # Current: On

Select mode 1: On 2: Off

Output: # Current: Off

Select mode 1: On 2: Off

Select Function Option

home screen

Hold for

5 seconds

through

--->

-----------------------

ARC enables a source connected to a display to route audio to an AVR or zone amp.

The S/PDIF port is used for two audio options, ARC or matrix source audio loop-out. When using

one, the other is disabled. By default the matrix comes with ARC turned off on all ports, this

enables the S/PDIF to loop-out the audio from the matrix source. To switch between ARC and

matrix source audio, ARC must be turned on or off. Enable or disable ARC through RS-232 (see

page 15) or front panel (see below).

1. Check to be sure the display supports ARC

2. Enable ARC on the HDMI output of the matrix through RS-232 (see page 14) or front panel

(see steps above)

3. Connect the HDMI Matrix output port to the ARC labeled input port on the display

NOTE: The Matrix must be connected to the display’s HDMI ARC input

4. Connect the source to a non ARC HDMI input port on the display

5. Connect the S/PDIF port to an AVR or Zone Amp

NOTE: The S/PDIF port used must be the same output number as the HDMI port connected

to the display

--->

Audio Return Channel (ARC)

Steps

S/PDIF

HDMI

Bidirectional HDMI w/ARC signal

S/PDIF audio loop-out

atlona.com Toll free: 1-877-536-3976

Local: 1-408-962-0515