Atlona AT-H2H-88M Matrix source audio loop-out

Matrix source audio loop-out

By default the matrix is enabled to de-embed source audio out through the S/PDIF port to an AVR

or zone amp.

NOTE: If audio does not pass through, check to make sure ARC is turned off.

NOTE: HD audio formats are not supported through S/PDIF.

Ex. Dolby TrueHD or DTS-HD Master Audio

atlona.com Toll free: 1-877-536-3976

Local: 1-408-962-0515

Contents

Main Table of Contents atlona.com Introduction Specifications Features Package Contents Panel Description Remote Control atlona.com Back Panel Page To set an input to an output To mirror all inputs and outputs -- Ex. Input 1 to output 1, input 2 to output 2, etc. To route one input to all outputs -- Ex. Input 5 to output 1, output 2, etc. Input # saved to Output # atlona.com To save an I/O route to memory * I/O route is current settings of inputs to outputs To load a saved I/O route Memory # saved Memory # loaded atlona.com Feedback= Saved port # EDID to Memory # [Failed/Passed] ---> ---> ---> atlona.com EX. Feedback= Save memory # EDID to input # Atlona EDID -ATL Pioneer EDID -PIO Toshiba EDID -TSB View Firmware/Baud Rate/FPGA settings View I/O settings EX. Page Matrix source audio loop-out 14 Command Local: 1-408-962-0515 The command codes are very sensitive, do not change capitalization, spacing, or lettering. RS-232 Connection RS-232 Set Up Baud Rate Updating and Resetting Updating firmware Resetting to factory settings Safety Information Safeguards Precautions Warranty Limited Warranty Customer Remedies No other warranties No liability for damages Atlona Product Registration