REMOTE CONTROL
1.Power: Press the button to turn on/off the unit.
2.Direct input selector: Press numerical number button to select your desired input source.
3.Void buttons (No function). If the button number is greater than the total input number of the unit then the button is of no function.
Pins definition of modem cable
| Splitter | Remote Controller | ||
PIN |
| Definition | PIN | Definition |
1 |
| NC | 1 | NC |
2 |
| T x D | 2 | R x D |
3 |
| R x D | 3 | T x D |
4 |
| NC | 4 | NC |
5 |
| GND | 5 | GND |
6 |
| NC | 6 | NC |
7 |
| NC | 7 | NC |
8 |
| NC | 8 | NC |
9 |
| NC | 9 | NC |
RS-232
RS-232 transmission format:
•Baud Rate : 9600 bps
•Data Bit : 8 Bits
•Parity: None
•Stop Bit: 1 bit
RS-232 command
•The command is combined with a characters and digits.
•This combination command code has to be separated by ASCII character SPACE
•The command will be executed after ASCII character “CR” input
•After ASCII character “CR” is entered, if the command is legal the unit will reply “OK” message
•If the command is illegal, The unit will reply “NG” message
Command Code | Comment |
PORT 1 | PORT 1 ON |
PORT 2 | PORT 2 ON |
PORT 3 | PORT 3 ON |
PORT 4 | PORT 4 ON |
PORT 5 | PORT 5 ON |
PORT 6 | PORT 6 ON |
PORT 7 | PORT 7 ON |
PORT 8 | PORT 8 ON |
SIGNAL 1 | ENABLE SIGNAL ENHANCE |
SIGNAL 0 | DISABLE SIGNAL ENHANCE |
POWER 1 | POWER ON |
POWER 0 | POWER OFF |
Toll free: | 4 | www.atlona.com |
Local: |