Section
01 Before You Start
Attaching the front panel
1Make sure the inner cover is closed.
2Replace the front panel by clipping it into place.
DISPLAY during feature demo operation can- cels the feature demo mode. Press DISPLAY again to start the feature demo mode. Remem- ber that if the feature demo continues operat- ing when the car engine is turned off, it may drain battery power.
About the demo mode
This unit features two demonstration modes. One is the reverse mode, the other is the fea- ture demo mode.
Important
The red lead (ACC) of this unit should be con- nected to a terminal coupled with ignition switch on/off operations. If this is not done, the vehicle battery may be drained.
Reverse mode
If you do not perform an operation within about 30 seconds, screen indications start to reverse, and then continue reversing every 10 seconds. Pressing BAND when power to this unit is turned off while the ignition switch is set to ACC or ON cancels the reverse mode. Press BAND again to start the reverse mode.
Feature demo mode
The feature demo automatically starts when power to this unit is turned off while the igni- tion switch is set to ACC or ON. Pressing
Use and care of the remote control
Installing the battery
Slide the tray out on the back of the remote control and insert the battery with the plus (+) and minus
!When using for the first time, pull out the film protruding from the tray.
WARNING
Keep the battery out of the reach of children. Should the battery be swallowed, immediately consult a doctor.
CAUTION
!Use only one CR2025 (3 V) lithium battery.
!Remove the battery if the remote control is not used for a month or longer.
!Do not recharge, disassemble, heat or dispose of the battery in fire.
!Do not handle the battery with metallic tools.
!Do not store the battery with metallic materi- als.
!In the event of battery leakage, wipe the re- mote control completely clean and install a new battery.
10 En