Atlona AT-PROHD82M user manual RS232, Protocol Commands

RS232

The Atlona AT-PROHD82M switcher can be controlled via the RS-232 serial control port to allow for interfacing to a PC, or similar third party control system.

The serial communication parameters are 9600 baud, 8 bit no parity and 1 stop bit. This is often referred to as 9600 8N1. When the unit recognizes a complete command it will perform the requested action. There is no delimiter character required.

The unit does not send out a message when a value is changed from the front panel or by IR control. If the switcher needs to be controlled in addition to the RS-232 control, you should regularly verify the unit’s status to

RS 232 SERIAL COMMANDS

1. Protocol Commands

All#	Transfer all input signals to matching output channels.
[x1] AV[x2]	Transfer the audio and video signals from input channel [x1] to
	output channel [x2]. Example: input 5 needs to be send to output 6,
	the commands would be x5AVx6
[x1] AV[x2],[x3],[x4]	Transfer the audio and video signals from input channel [x1] to output
	channels [x2], [x3] and [x4].
[x1] A[x2]	Transfer the audio signals from input channel [x1] to output channel [x2].
	Example: input 5 needs to be send to output 6, 8, 10, 15
	the commands would be x5AVx6,x8,x10,x15
Save[Y]	Save the present operation to the preset command [Y]. [Y] ranges from 0 to 9.
Recall[Y]	Recall the preset command [Y].
Vol100, Vol101,	Volume adjustment on output # 1
Vol102, Vol103,
Vol104, Vol105,
Vol106, Vol107,
Vol108, Vol109,
Vol110
Vol200, Vol201,	Volume adjustment on output # 2
Vol202, Vol203,
Vol204, Vol205,
Vol206, Vol207,
Vol208, Vol209,
Vol210
Clear[Y]	Clear the preset command [Y].

www.atlona.com toll free: 1-877-536-3976
	9
For International: 1-408-962-0515