Atlona AT-PROHD85M-SR user manual IR Remote Control, View RS232 codes on

5.If you wish to control the AT-PROHD85M-SR from a 3rd party control system connect an RS-232 cable between the matrix and the control system. Please use a straight RS-232 Cable for this connection .

(View RS232 codes on page 12)

7.For computer control connect a RJ45 cable to the TCP/IP port of the AT-PROHD85M-SR. Note: If the TCP/IP port is connected directly to a computer you must use a crossover CAT5 cable. If connect¬ed to a router use a straight wire CAT5 cable.

8.RS485 port: protocol utilized by compatible control devices to achieve longer distance cable runs over CAT5

9.Connect the supplied IR receiver cable to the AT-PROHD85M-SR to con¬trol the matrix switch from the supplied handheld remote control. Used when the AT-PROHD85M-SR is in an enclosure and the front panel IR window isn’t visible.

10.To manually select an input and output from the front panel follow these steps. Step

1: Press the desired output button. The corresponding output LED will start to flas Step 2: Press the desired input button. The output LED will change to the input selec¬tion and will continue to flash.

Step 3: Select the F/N button to enter and the LED will stop flashing.

IR REMOTE CONTROL

The AT-PROHD85M-SR remote can control the matrix either through the front face panel IR receiver window or the supplied IR receiver cable module. If you use a third party IR remote control you can learn the IR codes off of the matrix remote. If you use a third party IR remote sys-tem controller you can copy and paste the IR HEX code into the remote control software package. IR HEX codes can be found on the supplied CD.

There are 2 scenarios for code use:

1:Learn all 40 x codes in order to control each setup from the matrix location.

2:Learn 8 x codes for local zone control only.

VERY IMPORTANT:

When connecting IR receivers and IR emitters, be very careful as if they are re- versed the IR Eye will burn-out and also may damage the IR module inside of the switch and Receiver.

TX – Connects to the Switch

RX – Connects to the HDMI Receivers

Toll free: 1-877-536-3976	8	www.atlona.com
Local: 1-408-962-0515