OPERATING
MOUNTING
1.Slightly loosen the fixing screws on the weaver rail built into the scope.
2.Place the scope on the dovetail mount of the fire arm making certain that the mount aligns with the receptor attach- ment screw groove. Adjust as neces- sary.
3.Tighten the fixing screws.
NOTE: Receptor attachment screws may need to be tightened after continuous shooting.
The ATN Mounting System allows to change the position of the riflescope flex- ibly on the weapon in relation to a shooter
Rail Screws
Fixing Threaded projection aperture
by 1/3 of inch. Such positions are addi- tional to the fixed positions already avail- able on the weaver rail. For this purpose in the base of the mounting bracket there is a rail with a fixing projection. For doing this one needs to
To change the position of the riflescope on the weaver rail additionally follow the steps mentioned below:
1.Unscrew the two screws, which attach the rail to the mounting bracket.
2.Take the rail out of the groove.
3.
4.Place the rail into another groove.
5.Fix the rail with the two screws.
NOTE: If the rail is not taken out easily, screw up tight one of screws into the threaded aperture in the middle of a fixing projection of the rail. Continue rotation of the screw. Thus the screw will push out a rail from a groove.
FOCUSING
While holding the scope about two inches from your eye, quickly glance through the eyepiece at a featureless, flatly lit bright area such as a wall or the sky.
CAUTION: Viewing the sun can cause serious eye injury, never look at the sun with this product or even the naked eye.
If the reticle is not sharply defined instantly, turn the eyepiece (either direc- tion) a few turns.
Quickly glance through the scope again. If the focus has improved, but is still not perfect, continue focusing. If the focus condition become worse turn the focus the opposite direction.
LOCKING MECHANISM
There is a locking mechanism with fixa- tion screw for windage/elevation adjust- ment and zeroing mechanism.
Fixation screw of
locking mechanism
Slightly loosen the fixation screw before zeroing or windage/elevation adjustment.
After zeroimg or windage/elevation adjustment turn the fixation screw clock- wise, to lock the adjustment mechanism.
3
