6
Screw the 3 thumbscrews
la be led “A”, "B ” & ”C”, into th e
corresponding holes located on
the bottom of the DS-1.
Attach the 3 rounded
mushroom heads caps to the
ends of the locking screws. *
*A set of mushroom heads come
shipped with each Reactor 50
112/212.
Position the proper docking
template on the top of your
modeler.
Insert the docking template
along with the modeler into the
rear of the DS-1, locating and
positioning it in the notch of the
template frame.
Tighten down the thumbscrews
until modeler is held securely in
place.
After securing modeler,
connect the Input and,
Left/Right output connectors.
The Input cable is extra long
to accommodate modelers
that have their input jacks
located on the front.
Please note that there is
plenty of room to get to foot
controller connections etc. If
your modeler has a ON/OFF
switch, switch it ON now.
Use the power cable included
with the docking template to
connect between your
m ode le r’s pow er inpu t a nd the
DS-1s power output. THERE
IS NO NEED FOR AN
EXTERNAL POWER SUPPLY.
The DS-1 automatically
compensates for your
m ode le r’s voltag e and polarity.