Storm Series LCR Theater Speakers
Pre-Wiring
The audio/speaker cable runs should be routed from the head-end location to the speaker rough-in brackets (if used). At the speaker locations, securely fasten the speaker wire to the speaker rough-in bracket. If not using speaker rough-in brackets, staple speaker wire runs in a loose zigzag between the studs where the speaker is to be mounted to make it easier to fi nd the cable after the drywall is installed. Zig-zagging the cable also allows fl exibility in the placement of the speaker. Note: Do not run speaker wires closer than 12" from high voltage wires.
| | | | High |
Min | | | Voltage |
12” | Speaker | Wiring |
Wire | | |
| | | |
| | | | | |
Figure 3.6: Pre-Wiring In-Wall
Speaker
Cutout
Ceiling
Speaker
Wire
Figure 3.7: Pre-Wiring Ceiling | |
© 2007 • All rights reserved. | 7 |