vi
Alphabetical CLI command explanations
AccessControl
Controls access on a target node. Access to the target
node is keyed to the iSCSI qualified name of listed
initiators.
Note
AccessControl cannot be used with iSNS.
Default: disabled on the default node; enabled on all other
nodes
set AccessControl [default | Target Name] [enabled |
disabled]
get AccessControl [default | Target Name]
AccessEntry
Allows the addition or deletion of an initiator entry from
the access control list of a target node. The initiator name
must be formatted as an iSCSI qualified name and must
be between 1 to 223 characters, is case sensitive and
cannot be
all
.
Default: default all
set AccessEntry [default | Target Name | discovery]
[Initiator Name <delete> | all [delete]]
get AccessEntry [default | Target Name | discovery]
AutoMap
Automatically maps all target devices visible to the
iPBridge to iSCSI addresses. If you use no arguments, all
devices are mapped to the default target. If you specify a
target, all devices are mapped to that target. If you
specify
*,
each device is mapped to its own auto-named
target.
Automap <default | * | target name>
SaveConfiguration command required
AutoMapOnBoot
Regulates automatic device detection and mapping
(
AutoMap
) at startup.
Default: enabled
set AutoMapOnBoot [enabled | disabled]
get AutoMapOnBoot
AutoMapOnBootDelay
Specifies the duration of time in seconds that the iPBridge
waits before performing an
AutoMapOnBoot
operation.
AutoMapOnBoot
must be enabled for the
specified delay to take effect.
Default: 0
set AutoMapOnBootDelay [0 - 256]
get AutoMapOnBootDelay
BridgeModel
Reports specific model and firmware information.
get BridgeModel
BridgeName
Specifies the eight-character ASCII name assigned to the
iPBridge to identify individual units. It is not the World
Wide Name. Changes take effect immediately.
set BridgeName [name]
SaveConfiguration Restart command required
get BridgeName
ClearEventLog
Clears the contents of the event log. No new entries are
recorded until the operation is completed.
ClearEventLog
TailEventLog taileventlog
Time 00:00:00 set time 03:32:30
TimeZone EST set timezone pst
Username root set username barbara
VerboseMode enabled set verbosemode disabled
VirtualDriveResponse disabled get virtualdriveresponse
VLAN set vlan dp1 5 alpha1
Command Default Example