Atwood Mobile Products KN-COPP-B manual Installation rapide, Up Set Quick

Installation rapide

Retirez les trois piles AA ci-jointes et installez-les dans le récipient à piles. Placez soigneusement les drapeaux rouges d’avertissement de piles dans le récipient à piles. Respectez les indications des polarités de pile inscrites dans le fond du récipient à piles. L’affichage devrait indiquer 888 (figure 1).

Après environ 30 secondes, l’affichage 888 disparaîtra et un point noir en bas à droite clignotera toutes les 5 secondes (figure 2).

Votre alarme de monoxyde de carbone Atwood est maintenant opéra- tionnelle.

6

6

.label the on marker permanent in up) power from years (7 date by” “Replace the Write .alarm the of side the to affixed been has label a unit, the replace to date the identify help To .immediately replaced be should and accurately monoxide carbon detect longer no may device the years seven After .alarm the replace to time is it that indicate to seconds 30 every “chirp” will unit this up, power initial after years (7) Seven

.operational now is Alarm CO Atwood Your

.CO for monitoring begin will alram CO your seconds, 30 approximately After .well battery the of bottom the at markings polarity battery the Observe .well battery the into flags warning battery red the place Carefully .well battery the into them install and batteries AA enclosed three the Remove

Up Set Quick