|
| 7 |
INSTALLATION INSTRUCTIONS |
| |
| ||
| ||
|
|
|
CAUTION
CAUTION
TO AVOID DAMAGE TO DOOR AND OPERATOR ENSURE ALL DOOR LOCKS ARE DISABLED.
USE AN INTERLOCK SWITCH IF A LOCK IS REQUIRED TO RETAIN FUNCTIONALITY.
A MINIMUM OF TWO PERSONS ARE
REQUIRED FOR OPERATOR
INSTALLATION.
ENSURE A SAFE RIGID WORKING
PLATFORM IS AVAILABLE.
1)Locate the center of the door and mark a line on the wall directly above the door. Extend this line approximately 20” up the wall. See Figure 5.
3)Using the projected lines for location, mount a suitable wood block or angle iron, depending on the structure of the building, to the wall above the door opening as shown in Figure 7. Ensure the block or angle iron used will provide a sound and secure mounting pad for the operator rail front mounting bracket, see CAUTION warning below.
107096
107094
Figure 5
2)Slowly raise the garage door and observe the action of the top section. When the top section reaches the highest point (high arc), use a level and project a line from this point to the center of the door. See Figure 6.
107095
Figure 6
Figure 7
CAUTION
THE FRONT MOUNTING SURFACE FOR THE OPERATOR MUST BE SOUND AND SECURE. IF NECESSARY PROVIDE REINFORCEMENT IN THIS AREA BEFORE MOUNTING THE OPERATOR RAIL FRONT MOUNTING BRACKET.
