Audio-Technica AT-LP60 Tips For Better Performance, Specications

Tips For Better Performance

Type Belt drive turntable, fully automatic

Platter Aluminum

Motor DC servo-controlled

Speeds 33

RPM, 45 RPM

Wow and flutter Less than 0.25% (WTD) @ 3 kHz (JIS)

Signal-to-noise ratio >50 dB (DIN-B)

Cartridge Integral Dual Magnet™ stereo cartridge with diamond stylus

Output level

Pre-amp “PHONO” 2.5 mV nominal at 1 kHz, 5 cm/sec

Pre-amp “LINE” 150 mV nominal at 1 kHz, 5 cm/sec

Phono pre-amp gain 36 dB nominal, RIAA equalized

Power 120V AC, 60 Hz, 3W

Dimensions 360.0 mm (14.17") W x 97.5 mm (3.84") H x 356.0 mm (14.02") D

Net weight 2.98 kg (6.6 lbs.)

Furnished accessories Dual RCA (female) to 3.5 mm (

") mini-plug (male) stereo adapter cable; dual RCA (female) to 3.5 mm (

mini-plug (female) stereo adapter cable; 45 RPM adapter

Replacement stylus ATN3600L

Tips For Better Performance

• When opening or closing the turntable cover, handle it gently,

moving it either at the center or equally from both sides.

• Do not touch the stylus tip with your fingers; avoid bumping

the stylus on the turntable mat or a record’s edge.

• Clean the stylus tip frequently, using a soft brush with a

back-to-front motion only.

• If you use a stylus cleaning fluid, use it very sparingly.

• Wipe the dust cover and turntable housing gently with a soft

cloth. Use only a small amount of mild detergent solution to

clean the turntable and dust cover.

• Never apply harsh chemicals or solvents to any part of the

turntable system.

• Prior to moving the turntable, always unplug it from the AC

outlet and fasten the tone arm on the tone arm rest with the

vinyl twist-tie.