2
This device complies with Part 15 of the FCC rules.
Operation is subject to the following conditions:
(1)This device may not cause harmful interference and
(2)This device must accept any interference received, including interference which may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is unlikely
to cause harmful interference. However, if the equipment does cause harmful interference, the user will be required to correct the interference at own expense.
CAUTION! Electrical shock can result from removal of SpectraPulse® components’ covers. Refer servicing to qualified service personnel. No
The circuits inside the SpectraPulse® components have been precisely adjusted for optimum performance and compliance with federal regulations. Do not attempt to open the drm141 Digital Receiver Module (main assembly), aci707 Audio Control Interface, mtu101 Boundary Microphone Transmitter, mtu201 XLR Desk Stand Transmitter, or cei007 Charging/Encryption Interface. To do so will void the warranty, and may cause improper operation.
Notice to individuals with implanted cardiac pacemakers or AICD devices:
Any source of RF (radio frequency) energy may interfere with normal functioning of the implanted device. All wireless microphones have
3
Please note that your SpectraPulse® system operates in a frequency band in a way which may make its use subject to certain FCC and other regulatory agency restrictions and licensing requirements. No changes or modifications may be made to this equipment except by the expressly approved responsible party for compliance. Changes or modifications could void the user’s authority to operate the equipment, and will also void
Battery precautions
•Each mtu201 Wireless XLR Desk Stand is powered by 2 AA batteries; alkaline batteries are included, but rechargeable SANYO brand NiMH AA batteries are recommended.
•Each cei007 Charging/Encryption Interface comes equipped with 14 rechargeable
SANYO brand NiMH AA batteries. Note: Other models of NiMH batteries may work, but the cei007, mtu101 and mtu201 are optimized for use with SANYO NiMH AA batteries.
•SpectraPulse® cei007 Charging/Encryption Interface is intended only for use of mtu101 Boundary Microphone Transmitters and mtu201 XLR Desk Stand Transmitters equipped with rechargeable AA Nickel Metal Hydride (NiMH) batteries. Do not use the charging station for products other than the
Do not use the cei007 Charging/Encryption Interface to charge batteries of other types besides NiMH or damage may result.
•Rechargeable batteries must be charged before initial use or after prolonged
•When recharging, follow instructions in the SpectraPulse® Owners Manual.
•When inserting batteries into the mtu201, observe correct polarity as marked.
•Do not use a leaking battery. If battery leakage occurs, avoid contact with skin. If contact occurs, immediately wash thoroughly with soap and water. If battery leakage comes into contact with your eyes, immediately flush with water and seek medical attention.
•Do not expose the batteries to fire. Do not heat, deform, solder, disassemble or modify.
•Do not peel off or damage the outer tube of a battery.
•Do not use these batteries together with dry cells, other types of batteries, new and old batteries together, or batteries with different charge levels.
Note: This SpectraPulse® system is approved for indoor use only.
Note: See SpectraPulse® Owners Manual for full system specifications.
