Audio2000's AKJ780D manual DVD Output Connections

Basic Connections

4.Connecting Effects Using the EFFECT INSERT:

1.Connect one end of the ¼-inch stereo audio cables to the GUITAR EFFECT, KEYBOARD EFFECT, or MIC EFFECT inserts on the rear panel of the AKJ780D.

2.Connect the other end of the ¼-inch stereo audio cables to the sound effect device.

3.By using the built-in EFFECT INSERT you can add external effects to vocals and/or guitar or keyboard or microphone without compromising the quality of the original signal.

The insert is a break point in the input channel signal path, It allows the signal to be taken out from this AKJ780D, through an external equipment (such as a Limiter, Compressor, Equalizer, Effector) and then back to the AKJ780D, the input jack can be used with ¼-inch TRS phone jack, the signal will be sent out through the TIP of the ¼-inch TRS phone jack and back to the AKJ780D through the RING of the ¼-inch TRS phone jack.

DVD Output Connections

DVD Output Connections

1.Connecting to a Dolby Pro Logic Amplifier

The AKJ780D allows DVD audio outputs for 5.1 or 7.1 configurations.

With a 5.1 amplifier, you will need six RCA patch cables. Connect the plug from one side of each cable to the ML, CEN, SL, MR, SW and SR outputs on the AKJ780D. Connect the plug from the other side of each cable to the corresponding ML, CEN, SL, MR, SW and SR inputs on your 5.1 amplifier.

A 7.1 Pro Logic configuration requires 2 additional RCA cables to be connected from the FL and FR outputs of the AKJ780D to your 7.1 Amplifier.