14
Troubleshooting
Symptom | Cause | Remedy |
Display is off | Power cord incorrectly plugged | Make sure the power cord is correctly |
No sound |
| plugged into the wall outlet |
| Check fuses in the fuse panel (after | |
|
| unplugging the power cord from the wall |
|
| outlet) above the IEC inlet and replace |
|
| them with new ones of the same type |
|
|
|
Display is on | Low volume | Turn volume knob right |
No sound | Faulty or incorrectly plugged connectors | Check cords and their connection |
| between Maestro Settanta and the |
|
| speakers |
|
| Off or incorrectly selected source | Check if the source is on and active and if |
|
| it is correctly selected using the in selector |
| Faulty or incorrectly plugged signal | Check cords and their connection |
| connectors between Maestro Settanta and |
|
| the sound source |
|
| Contact you local Audio Analogue retailer | |
|
| to check and eventually replace burned- |
|
| out fuses |
Recording is impossible | Incorrectly selected source | Select the right source using the recording |
|
| selector |
Amplifier turns off when plugged to power | One or both speakers out are short- | Check the connection of the speakers |
outlet | circuited | connectors to both ends |
Remote controller doesn’t work | No battery/ | Place/replace battery (2 ‘AAA’ batteries) |
|
|
|
| You’re standing too far or on an exceeding | Get closer to the unit or reduce angle |
| angle from the front panel |
|
If the suggested remedies should not work or the problem is not shown in the list above, please contact your local Audio Analogue retailer.
